Assembly Of The Elevator - SpaceraiL Spacewarp Level 2.1 Instruction Manual

4
A sse m b ly o f th e e le v a to r
1. Insert the 300m m shaft into the
gearbox (fg. 06-1)
2. Slide the elev ator (12 pcs) onto
the 300m m shaft (fg. 06-2
Please note the correct direction
of rotation
3. Insert 3 further 300m m shafts
into the ex act pre-defned
positions on the g earbox (fg . 06-3)
4. Allow the 3 shafts to snap into
place (pic. 06-4). T ake care that
the elev ator rings are properly
located
See pages 6+ 7 for the proper
locations of the elev ator rings
5. Insert the 4 shafts into the
elev ator cov er (fg. 06-5). T ake
care that the shafts are properly
located
6. Now attach 3 rail stands [A 6] to
the elev ator ring (fg. 06-6)
06-1
[S1] Shaft 300m m
[G 1] G earbox
06-4
[E2] Elev ator ring

Assembly of the elevator

06-2
[E1] Elev ator helix
Av oid that there is a gap betw een
gearbox and elev ator helix . Otherw ise
the elev ator w ill not operate properly
Make sure conv ex red parts point up
and ev erything is correctly seated
[E3] Elev ator cov er
06-5
[S1] Shaft 300m m
06-3
Please note the correct direction
of rotation
06-6
[A 6] Rail stand
[A 6] Rail stand
5