Beef Eater SIGNATURE Series Assembly And Operating Instructions Manual page 13

ASSEMBLING THE BARBECUE
Fit the hanging brackets
The appliance can be supported in the enclosure either by
sitting directly on the base or by hanging the appliance from
the benchtop.
If the hanging option is preferred, mount the supplied
hanging brackets to the sides of the burner box with the
supplied bolts and nuts.
Warming rack
Position the warming rack onto the 2 burner box side
wall brackets.
NOTE: When not required the rack can be positioned
vertically out of the way behind the brackets. (see diagram)
Fit the cooking plate and grills
Position the cooking plate and grills in the configurations you
require ensuring though, that the grills are always positioned
above the vaporizers.
To allow for oil from the cooking plate and grills to flow into
the oil collection trough the drain holes must be positioned
at the front of the barbecue.
Lifting holes
at back
Horizontal hotplate option
If the cooking plate is needed to be horizontal, position the
drain holes to the back of the barbecue.
This option may be preferable when cooking eggs.
NOTE: Oil flow will not occur in this configuration.
Non-recommended hotplate configuration
WARNING
WARNING
Having 2 hotplates together may cause damage to the
appliance as well as excessive temperatures in surrounding
surfaces.
Drain holes
at front
ASSEMBLING THE BARBECUE
13