Table of Contents
Advertisement
SE LP10
FE6600/BL6600/MP6600 Series Multi-point Lock
Installation Instructions
7
Installation Instructions, continued
Installation of SE LP10 Reader & Trim Bezel
h
a. Fit trim bezel around the reader. Ensure access hole in
the bezel aligns with screw hole on reader. The reader
should be mounted so the holes face the bottom of
door. (See figure to the right)
b. Align top of reader with top of backplate. Pivot reader
down until seated.
Guide wires as needed to avoid pinching.
c. Secure the reader with (1) #6-32 x 3/8" Phillips or
anti-tamper security torx screw to the mounting plate
(See figure below).
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Observe precautions for handling electrostatic senstive devices.
If the SE LP10 reader is installed with a module (See below), make sure that the reader is
powered down when inserting/removing the module; i.e., do not "hot-plug" (remove/insert
while reader is powered) module as it may damage the reader.
Detail
Reader
Module
14
Reader
Harness
FM456 08/20
Advertisement
Table of Contents
