Table of Contents
Advertisement
Fluidmesh components in real time, based on an optimal, software-
determined path. In addition, the absence of any single point of failure
greatly increases reliability when compared to any other wireless or wired
data-transmission technology.
Figure 2. Fluidmesh Mesh Networking Architecture
3.3. Fluidmesh Network Addressing
3.3.1. Bridge IP addressing
If needed, the Cisco FM4500 Mobi can be operated in Bridge mode. This
creates a single point-to-point connection between two network segments.
A simplified example of a Bridge mode connection is shown in
(page
19).
As shipped from the factory, the wired ethernet ports of all Fluidmesh
hardware components are assigned the same default IP address of
192.168.0.10/24.
No default IP address is associated with the wireless interface.
© 2021 Cisco and/or its affiliates. All rights reserved.
Getting Started
Figure 3
Page 18 of 174
Advertisement
Table of Contents
