Cisco Network Addressing; Bridge Ip Addressing - Cisco FM1200 Installation And Configuration Manual

greatly increases reliability when compared to any other wireless or wired
data-transmission technology.
Figure 3. Cisco Mesh Networking Architecture

3.3. Cisco network addressing

3.3.1. Bridge IP addressing

If needed, the Cisco FM1200 Volo can be operated in Bridge mode. This
creates a single point-to-point connection between two network segments.
A simplified example of a Bridge mode connection is shown in
(page 20).
As shipped from the factory, the wired ethernet ports of all Cisco
hardware components are assigned the same default IP address of
192.168.0.10/24.
No default IP address is associated with the wireless interface.
© 2021 Cisco and/or its affiliates. All rights reserved.
Getting Started
Figure 4
Page 19 of 175