Table of Contents
Advertisement
To use the constant ping and automatic reboot functions, do the following
steps:
1.
Click the -ping softdog link under NETWORK CONTROL in the
left-hand settings menu.
• The PING SOFTDOG dialog will be shown
(page
Figure 28. Configurator GUI (Ping Softdog dialog)
2.
To set up a constant ping to one or more IP addresses, do the
following steps:
1. Enter the IP address in the field to the left of the Add IP
2. Click the Add IP button.
3. To delete an IP address from the IP list, click the red
3.
To automatically reboot the unit if connectivity is lost between the
unit and any IP address, do the following steps:
1. Check the Reboot: check-box.
2. Click the Save button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
74)).
button.
• The IP Address will be added to the IP list.
• There is no limit on the number of IP addresses
that can be entered.
cross to the right of the IP address listing.
(Figure 28
Page 74 of 174
Advertisement
Table of Contents
