Fluidmesh 1200 VOLO
greatly increases reliability when compared to any other wireless or wired
data-transmission technology.
Figure 3. Fluidmesh Mesh Networking Architecture
3.3. Fluidmesh network addressing
3.3.1. Bridge IP addressing
If needed, the Fluidmesh 1200 VOLO can be operated in Bridge mode.
This creates a single point-to-point connection between two network
segments. A simplified example of a Bridge mode connection is shown
in
Figure 4 (page
As shipped from the factory, the wired ethernet ports of all Fluidmesh
hardware components are assigned the same default IP address of
192.168.0.10/24.
No default IP address is associated with the wireless interface.
© 2020 Cisco and/or its affiliates. All rights reserved.
19).
Page 18 of 169