Table of Contents
Advertisement
Figure 54. Management Settings dialog (Change
Username and Password)
2.
Enter the new administrator user name in the Username: field.
3.
Enter the current password in the Old password: field.
4.
Enter the new password in the New password: field.
5.
Confirm that the new password is correctly spelled by checking
the Show Password: check-box to show the text of the
password, then re-entering the password in the Confirm New
password: field.
6.
Save the changed password settings by clicking the Change
button. Alternatively, revert to the old password settings by
clicking the Reset button.
Enabling remote access to the unit by Telnet
The TELNET ACCESS section contains controls to enable remote access
to the unit using Telnet.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
Keep the Administrator name and password in a safe
place. If the Administrator name and password are
lost, the only way to log in to the unit is to do a hard
reset.
If you need to do a hard reset, refer to
unit to factory defaults" (page 138)
information.
"Resetting the
for more
Page 127 of 174
Advertisement
Table of Contents
