Table of Contents
Advertisement
IMPORTANT
Use of this window requires extensive familiarity with the
RADIUS networking protocol. Do not change these settings
unless there is a specific need to do so.
To change the RADIUS settings for the Fluidmesh unit, do the following
steps:
1.
Enable and configure network time protocol (NTP) as shown in
"NTP Configuration" (page
2.
Click the -radius link under ADVANCED SETTINGS in the left-
hand settings menu.
• The RADIUS dialog will be shown
Figure 44. Configurator GUI (RADIUS dialog)
3.
Choose the RADIUS mode for the device by clicking the RADIUS
Mode drop-down and selecting one of the following options:
• Disabled: RADIUS functionality will be disabled.
• Enabled: RADIUS functionality will be enabled, and the
configuration options will be shown.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
112).
(Figure 44 (page
110)).
Page 110 of 174
Advertisement
Table of Contents
