Table of Contents
Advertisement
an optimal link signal strength of approximately -55 dBm on both sides of
the radio link while not exceeding the user-defined maximum transmission
power threshold.
NOTE
if Max TX Power is set to AUTO, the maximum transmission
power may vary at any moment depending on the operating
frequency of the unit, atmospheric conditions, and other
factors.
If the unit's country selection is set to any country within
Europe, TPC is automatically enabled.
To use the Max TX Power setting, do the following steps:
1.
Click the Select TX Max Power: drop-down menu.
2.
Choose the correct transmission power level from the following
list of options:
• Transmission power can be manually adjusted from -3
dBm to 24 dBm.
• If you select the AUTO option, the unit will automatically
choose the most efficient transmission power level
according to prevailing conditions. However, the unit will
not exceed the last manually selected Max TX Power
parameter.
3.
Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.
Using the Select Antenna Gain setting
This setting controls the maximum antenna gain in dBm. By default,
antenna gain is not pre-set at the factory.
To use the Select Antenna Gain setting, do the following steps:
1.
Click the Select Antenna Gain: drop-down menu.
2.
Choose the correct antenna gain level. Gain can be manually
adjusted from 0 dBm to 36 dBm.
3.
Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.
Using the Data Packet Encryption setting
This setting controls whether Advanced Encryption Standard (AES)
encryption is applied to outgoing data packets.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Page 95 of 174
Advertisement
Table of Contents
