Table of Contents
Advertisement
3.
Specify the country in which the unit is installed by selecting the
correct option from the Country drop-down menu.
4.
Specify the unit's operating frequency by clicking the correct
option in the Frequency (MHz) drop-down.
• You can change the frequency of each radio link in order to
minimize interference with other wireless networks
operating in the same area. The frequencies shown on the
Frequency (MHz) selector are the carrier frequencies.
• Operation in the 4.9 GHz band must be enabled using a
Fluidmesh software plug-in. Refer to
management" (page 130)
band is not available in Brazil and Canada.
5.
If Advanced configuration mode was selected, choose the
required channel bandwidth from the Channel Width (MHz)
drop-down. Note that the radio units on both sides of a wireless
link must be set to the same channel width value. A channel
width mismatch will result in degraded communication between
the units.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
If a shared passphrase is defined, the same
passphrase must be used for all Fluidmesh units in
the same network.
The shared passphrase can be composed of any
ASCII characters except the following: '`"\$=
CAUTION
Different countries frequently have differing
telecommunications regulations. If the Country listing
is not set correctly, the unit may violate national
telecommunications legislation.
CAUTION
Make sure that the chosen country listing matches
the country in which the unit is installed before
changing the Frequency (MHz) value.
for details. Note that the 4.9 GHz
CAUTION
Before finalizing the settings on the WIRELESS
RADIO window, refer to
"Important considerations
for wireless settings" (page 69)
contains important information that may influence
your choice of wireless settings.
"Plug-In
below. This section
Page 68 of 174
Advertisement
Table of Contents
