Table of Contents
Advertisement
Use care in removing and installing power modules. To remove a power module:
1.
Remove the front cover.
The cover has magnetic latches on the left and right sides that hold it in place.
2.
Loosen the captive screws at the sides of the power module and slowly pull the power module out of the
cabinet.
3.
Treat the original and replacement power modules with care to avoid damaging connectors or internal
circuitry. Label the original power modules with masking tape or some other identifier. Record the serial
number of the replacement power modules for your warranty.
4.
Insert the replacement power module by sliding it carefully into the cabinet.
5.
Tighten the captive screws to the UPS cabinet.
6.
Replace the front cover.
Figure 80. Power Module Replacement
9 9 . . 6 6
U U P P S S F F i i r r m m w w a a r r e e U U p p g g r r a a d d e e
To ensure you have the most up-to-date content and information for this product, please review the latest
manual revision on our website,
FW upgrade program and instructions are located at the following web link: https://www.eaton.com/9PXM.
Front Covers
Power Module
https://www.eaton.com/9PXM
4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 09
Captive Screws
IMPORTANT
UPS Firmware Upgrade
99
Advertisement
Table of Contents
