Dispensing Hot Water; Auto Shut-Off; Programmable Dosing; Grind Size Adjustment - Dualit BEAN TO GO Instruction Manual & Guarantee

DISPENSING HOT WATER

CAUTION: WATER WILL BE HOT. SUBMERGE THE NOZZLE TO REDUCE
SPLASHING. The hot water dispense time can be adjusted between 30-350ml to suit your
preference by following programmable dosing instructions.
1 PREPARE 2 START DISPENSING
Ensure the Water Tank is Press Hot Water Button to
filled with water. dispense the hot water.
Caution: The Hot
Water Nozzle may be
hot.

AUTO SHUT-OFF

1 STANDBY 2 TURN ON
When the machine is left Ensure the External Drip
idle, it will auto shut-off. The Tray is in place. Press the
time taken for this depends Power Button to turn the
on what mode the machine machine on. Water will
is set to, see page 11 for purge through the Coffee
more details. Nozzle.
3
STOP DISPENSING
Press the Hot Water Button
again to stop dispensing.
Note: The hot water will
automatically turn off after
45 seconds
20

PROGRAMMABLE DOSING

The factory setting of the machine is programmed to 35ml for Espresso,
70ml for Lungo and 140ml for Hot Water. Both Lungo and Espresso modes
can be adjusted between 30-250ml to suit your taste preference.
2 ADJUST VOLUME
1 DISPENSE DRINK
Select the drink you wish Once the drink is dispensing,
to adjust the volume of and press and hold down the
press the relevant button relevant dispense button
once to start dispense. until you have reached your
desired volume. At this
point, release the button.

GRIND SIZE ADJUSTMENT

1 REMOVE COFFEE 2 START GRIND AND
BEAN HOPPER ADJUST LEVEL
COVER
Plug in the machine and Dispense a drink to ensure the
press the Power Button machine is actively grinding (page
to turn on. Using the cut-out 17). Twist the Grinder Knob
of the Water Tank handle, lift to the desired setting. A larger
out the Coffee Bean Hopper circle indicates a coarser grind
Cover. whilst a smaller circle indicates a
finer grind.
3 CONFIRMATION
The machine will beep twice
to indicate that the new
volume has been set.
3 REINSTALL
HOPPER COVER
Align the Coffee Bean
Hopper Cover with the
Hopper and push in. The
top of the lid must be flush
with the machine, this will
ensure the Coffee Hopper
Lid Seal is engaged.
21