Cleaning - Dualit BEAN TO GO Instruction Manual & Guarantee

CLEANING

It is recommended to clean your machine after each day of use in order
to extend its life. Before cleaning, make sure your machine is
switched off, unplugged and allowed to cool.
1 REMOVE AND 2
DRAIN EXTERNAL
DRIP TRAY
Empty the contents of the Remove Internal Drip Tray
External Drip Tray into a by pulling on the handle.
sink.
4 5
DRAIN INTERNAL
DRIP TRAY
Drain the contents of the Press on the bottom of the
Internal Drip Tray into a Service Door to raise its
sink, then wash and dry. top edge. Pull on the top
edge to remove the service
door. Wipe inside of Service
Door.
REMOVE INTERNAL 3 EMPTY GROUNDS
DRIP TRAY CONTAINER
Remove the Grounds
Container from the Internal
Drip Tray and empty the
contents into a bin. Rinse
the Grounds Container with
warm water and dry off. Place
Grounds Container to one side.
REMOVE SERVICE 6 REMOVE INFUSER
DOOR
Remove the Infuser by
pressing both the orange
buttons inwards.
24
CLEANING -
CONTINUED
7 RINSE INFUSER 8
Rinse Infuser under tap Use the supplied Cleaning
with warm water. Ensure to Brush to clean the Powder
dry afterwards. DO NOT Outlet above the Infuser
PUT IN DISHWASHER Support.
OR SUBMERGE UNDER
WATER.
10 REPLACE SERVICE 11
DOOR
Align the Service Door's two Place the Grounds Container
metal pins into the slots of the onto the Internal Drip Tray
appliance body. Once aligned, and slide into the machine.
push the Service Door into The front of the Drip Tray will
place. be flush with the machine, if it
is not, there is likely to be an
obstruction.
9
CLEAN INSIDE OF INSTALL INFUSER
MACHINE
Push the Infuser into the
Infuser Support. Please
ensure that both of the
orange clips engage. There
will be an audible click once
engaged.
INTERNAL DRIP 12 REMOVE STEAM
TRAY INSTALL TUBE METAL
COVER AND RINSE
Pull the Steam Wand Metal
Cover downwards to
remove. Rinse with warm
water and place onto a
clean surface.
25