Descale; Empty System; Manual Rinse - Dualit BEAN TO GO Instruction Manual & Guarantee

DESCALE

HARD WATER WILL CAUSE LIMESCALE BUILD-UP, RESULTING IN BLOCKAGES THAT
CAUSE PERMANENT DAMAGE. See Limescale Warning on page 8. The machine will display
a warning when descale is overdue. It is essential that a compatible descaler is used -
visit www.dualit.com/accessories for descaler options. See page 10 for Button and Warning
Symbols. The descale process takes approximately 20 minutes.
1 FILL WATER TANK 2
AND ADD
DESCALER
Ensure the Water Tank Place a 2L container
is filled with water before underneath the Coffee
adding descaler. Ensure Nozzle and Steam Nozzle.
that a compatible descaler Plug in Power Cord and
is used and that any water press the Power Button
softners are removed before to turn the machine on.
descaling. Water will purge through
the Coffee Nozzle.
4 SELF CLEAN 5
When the Water Tank
Warning and Espresso
The Descale Warning
Button flash, remove
symbol will flash during the
the Water Tank, empty
descale process. Stand away
and rinse to remove all
from the machine during this
remaining descale solution.
process. Liquid will dispense
from the Nozzle and
Steam Wand intermitently.
Caution: Hot.
3
TURN MACHINE ACTIVATE
ON
Press and hold the Power
and Espresso Buttons
for 5 seconds. Two beeps
will sound and the Descale
Warning / Espresso Button
will flash. Press the Espresso
Button to start descale
process.
REMOVE WATER 6 FINISH
TANK
Fill the Water Tank with fresh
water and install back in the
machine.
The machine will automatically
start to dispense water out of
the Nozzle and Steam Wand
and will switch off once the
dispense cycle is complete.
Refit water softner.
22

EMPTY SYSTEM

If you are not going to use your machine for a long period of time, it is
recommended that you use the Empty System Function. This process will
drain all of the water out of the system through the Steam Tube, preventing
the chance of limescale build up. See page 10 for Button and Warning
Symbols.
1 ACTIVATE 2
Ensure a 150ml container When the Empty System
is below the Steam Wand. warning is displayed, remove
When the machine is turned the Water Tank and place
on, hold down the Power on the side.
Button and Lungo Button
for 5 seconds. Two beeps
will sound.

MANUAL RINSE

It is recommended that a Manual Rinse is conducted at the end of each day the machine is
used. This process flushes water through the Coffee Nozzle, removing coffee residue from
inside the machine and therefore reducing the chance of mould build up. See page 10 for
Button and Warning Symbols.
1 2
ACTIVATE
Ensure a 150ml container is The machine will dispense
below the Coffee Nozzle. a small amount of water
When the machine is turned through the Coffee Nozzle
on, hold down the Power and into the container
Button and Hot Water before returning back to the
Button for 5 seconds. Two menu.
beeps will sound.
3
REMOVE WATER EMPTY SYSTEM
TANK
Once the Water Tank is
removed, water will pour
out of the Steam Nozzle.
The machine will then turn
off.
RINSE
23