Water Filter Replacement; Before First Use; Indicator Light - Dualit CINO Instruction Manual & Guarantee

WATER FILTER REPLACEMENT

WATER FILTER SOAK
1 2
Remove the Water Filter Soak for 5 minutes to activate
Holder and disassemble. Place the Water Filter. Discard the
1x Water Filter inside the Filter water. The water only needs
Basket. Click the Filter Basket to be activated before first use.
back onto the Water Filter From then on, you can fill the
Holder and locate in Water Water Tank as normal.
Tank.

BEFORE FIRST USE

STEAM VALVE 2 FILL
1
H²O
Remove the Water Tank
CAUTION: Ensure the Drip
and pour fresh water into the
Tray is located against the
Water Filter Holder. The water
front of the machine. Ensure
the Steam Valve is in the closed will flow through the Filter. Top
position. Warning - Risk of up as the level drops. Maximum
Scalding- Keep hands away fill level is the top of the Water
from the Outlet at all times. Filter Holder. Do not overfill.
REPLACEMENT
3
DATE
Once Water Filter has been
replaced, turn the Water Filter
Replacement Indicator to the
required month.
Daily use: Replace Water Filter
every month.
Light use: Replace Water Filter
every two months.
3 WATER TANK
Place the Water Tank into the
machine, pressing down firmly.
Ensure the Float is facing
towards the front. The Water
Tank Lid will sit flush with the
top surface when the Water
Tank is fitted correctly.
08
BEFORE FIRST USE
- CONTINUED
TURN

INDICATOR LIGHT

4 5
ON
Plug the machine in and turn The Indicator Light will flash
on. The ON/OFF switch will Green whilst warming and stop
illuminate Red. flashing when ready to use. If
it's Amber or Red, see Quick
Reference Guide on page
09. Note: The machine may
whistle whilst pre-heating. This
is normal operation.
INDICTOR LIGHT:
QUICK REFERENCE GUIDE:
To help understand each Indicator Light status, see the table below.
INDICATOR LIGHT
Red and Amber (Flashing)
Green (Flashing/ Solid)
Amber (Flashing/ Solid)
Red (Flashing/Solid)
Red (Quick Flash)
REMOVE NIB
6
Remove the Thermometer
Nib Protector from the
Thermometer. Clip the
Thermometer onto the side
of the Milk Jug.
MEANINGS
Re-fill Water Tank.
Machine is warming up to operating
temperature. Once Green illumination is solid,
the machine is ready to use.
Descale Required.
Machine in Lock Mode. Carry out mandatory
Descale.
In Descale Mode.
09