Warming Milk; Frothing Milk - Dualit BEAN TO GO Instruction Manual & Guarantee

WARMING MILK USING STEAM
IMPORTANT NOTICE: After each use, wipe the Steam Wand & flush the inside of
the Wand by dispensing water. It is recommended to use a chilled Milk Jug and fresh semi-
skimmed milk straight from the fridge for best results. Note: skimmed and full fat can also be used.
Keep hands away from the Outlet at all times. Caution: Hot! Risk of scalding.
REMOVE STEAM
1 2 PURGE STEAM
WAND METAL
WAND
COVER
Pull the Steam Wand Metal Direct the Steam Wand at
Cover downwards to the drip tray and press the
remove. Steam Button. Please note
that some water will be
ejected. The Steam Indicator
Light will flash until the boiler
is at the correct temperature.
START STEAMING MILK
4 5
TEMPERATURE
Once the Steam Indicator Once the milk is at the desired
Light is solid, press the Steam
temperature, turn off the
Button. The steam will flow
steam by pressing the Steam
from the Nozzle and through
Button. Ensure the steam is
the milk. Take care not to
turned off before removing
splash the milk.
the Wand from the Jug.
Pour immediately. Risk of
Note: The steam will stop
scalding.
automatically if left on for 90
seconds
3 ADD MILK
Add milk to a Milk Jug. Hold
the Jug by its handle and tilt
at a slight angle. Place the
Steam Wand close to the
edge of the jug, with the tip
close to the bottom.
6
METAL STEAM
COVER INSTALL
To prevent damage to your
machine, activate the Hot
Water Function and wipe
the Steam Wand clean.
Wait 30 seconds for the
Steam Wand to cool down
before installing the Metal
Steam Cover.
18

FROTHING MILK

IMPORTANT NOTICE: After each use, wipe the Steam Wand & flush the inside of
the Wand by dispensing water (page 18). It is recommended to use a chilled Milk Jug and
fresh semi-skimmed milk straight from the fridge for best results. Note: skimmed and full fat can
also be used. Keep hands away from the Outlet at all times. Caution: Hot! Risk of scalding.
PURGE STEAM ADD MILK
1 2
WAND
Ensure the Steam Wand Metal Add milk to a Milk Jug. Hold
Cover is in place. Direct the the Jug by its handle and tilt
Steam Wand at the drip tray at a slight angle. Place the
and press the Steam Button. Steam Wand close to the
Please note that some water will edge of the jug, with the tip
be ejected. The Steam Indicator close to the bottom.
Light will flash until the boiler is
at the correct temperature.
FROTHING
4 5
Lower the Steam Wand Gently tap the Milk Jug
into the Jug so that the tip against the worktop to
is 1-2cm below the milk's collapse any large bubbles.
Swirling will mix the
surface. Once the milk has
milk with the froth. Pour
reached the desired level of
immediately.
froth, press the Steam Button
to turn off the steam. Ensure
the steam is turned off prior
to removing the wand from
the Jug.
3 START STEAMING
Once the Steam Indicator
Light is solid, press the Steam
Button. The steam will flow
from the Nozzle and through
the milk. Take care not to
splash the milk. Note: The
steam will stop automatically if
left on for 90 seconds
6
TAP MILK JUG CLEAN
To prevent damage to
your machine, activate
the Hot Water function
and clean the Steam
Wand and Metal Cover.
19