Dispensing Hot Water; Cleaning - After Each Use - Dualit 3 in 1 Coffee machine Instruction Manual & Guarantee

DISPENSING HOT WATER

CAUTION: WATER WILL BE HOT AND BE DISPENSED AT HIGH PRESSURE.
SUBMERGE THE WAND TO REDUCE SPLASHING.
1 2
PREPARE SELECT WATER
Remove the froth nozzle Set the steam/water
from the steam wand. selector switch to the water
Caution: Wand may be hot. setting.
Ensure the water tank is
filled with water.
4 5
START DISPENSING
INSERT WAND
Turn the control knob to
Insert into a deep jug or
the steam/water position to
teapot and point the wand
start the water flowing. You
to a side wall to reduce
will hear the pump; this is
splashback.
quite normal.
3
WAIT 40 SECONDS
Wait for the temperature
indicator to go out.
6
STOP DISPENSING
To stop the flow, turn the
control knob to the 'off'
position. The machine will
purge to get ready for the
next coffee.
14

CLEANING - AFTER EACH USE

BEFORE CLEANING, MAKE SURE THE MACHINE IS SWITCHED OFF, UNPLUGGED
AND ALLOWED TO COOL. Do not wash any of the plastic accessories in a dishwasher.
1 2
THE FILTERS DRIP TRAY
Empty the drip tray regularly. If
Turn the filter holder upside
BIN
the red tray full indicator is
down over a bin and knock
out the grounds. Be careful visable, empty immediately.
not to throw away the cup Remove the non-slip mat and
filter. rinse after each use.
4 5
WIPE THE WAND fLUSh ThE
STEAm wAND
After each use, clean the ImPORTANT NOTICE:
wand with a damp cloth. After each use, flush the
There should be no milk steam wand by dispensing
residue visible. water or steam, this will
remove any milk residue
from inside the steam wand.
3
THE NOzzLE
Pull the froth nozzle off the
wand and wash under
running water to remove
any milk residue.
6
EMPTY WATER
Empty and rinse out after
each session and refill with
fresh water just before you
make your next round of
espresso.
15