Setting Up - Dualit BEAN TO GO Instruction Manual & Guarantee

SETTING UP

Ensure that your machine is unplugged and cool before starting. Remove all packaging and
protective films from the Appliance, including the protective cover on the Control Panel, then
follow the next steps to ensure your machine is set up correctly. This process will help you
achieve optimum performance and will take approximately 15 minutes to complete. Note: The
Control Panel will not work with the protective cover in place.
IMPORTANT NOTICE:
PRODUCT FAILURE
DUE TO THE BUILD
UP OF LIMESCALE
IS NOT COVERED BY
GUARANTEE. Dualit
recommends descaling regularly,
in a well-ventilated area, to
prevent limescale build-up in the
machine. See Limescale Warning
on page 8 for frequency in your
area in accordance with the
hardness of your water. Dualit
recommends the use of an
Register your product at
OSCAR Water Softener Bag in
dualit.com. This will only
all areas. See page 8 for further
take 60 seconds. You will
guidance. For more information,
need the product model
visit our website dualit.com/
and serial number that are
products/machine-care or
on the rating label on the
contact our Customer Services
base of the product.
on 01293 652500
2 3
INTERNAL DRIP
TRAY INSTALL
Install the Internal Drip Tray Press on the bottom of the
into the machine. The front Service Door to raise its
of the Drip Tray must be top edge. Pull on the top
flush with the machine, if it edge to remove the Service
is not, there is likely to be an Door.
obstruction.
1 CHECK GROUNDS
CONTAINER
Remove Internal Drip
Tray by pulling on the
handle. Check that the
Grounds Container is in
place.
4
REMOVE SERVICE REMOVE INFUSER
DOOR
Remove the Infuser by
pressing both the orange
buttons inwards.
Note: The
Light will turn on when the
infuser is removed.
12
SETTING UP
5 RINSE INFUSER
Rinse Infuser with warm
water and dry afterwards.
DO NOT PLACE IN
DISHWASHER.
8
EXTERNAL DRIP
TRAY
Ensure the External Drip
Tray Cover is placed into
the External Drip Tray. Push
Warning the External Drip Tray into
the cut-out at the front of
the machine. The tray will
secure itself with magnets.
- CONTINUED
6 INFUSER INSTALL 7
Push the Infuser into the Infuser Align the Service Door's two
Support. Ensure that both metal pins into the slots of
of the orange clips engage. the appliance body. Once
There will be an audible click aligned, push the Service
once engaged correctly. The Door into place.
Warning Light will show if
the Infuser is installed incorrectly.
9
POSITION 10
Position in a safe space. This Lift out the Water Tank using
must be away from heat
the Handle. Rinse before filling
sources, water taps and not
with fresh water. DO NOT
in a cupboard. The surface
USE ANY OTHER LIQUID
must be flat in order to
Maximum fill level is the
keep the machine level and
MAX Marker. Do not
stable.
overfill.
13
SERVICE DOOR
INSTALL
REMOVE AND FILL
WATER TANK