Remove the bobbin from the bobbin
case.
Hold the bobbin case with one hand.
Insert the bobbin so that the thread
runs in a clockwise direction (arrow).
Pull the thread through the slit and
under the finger.
Leave a 6 inch tail of thread.
Make sure the bobbin case finger fits
into the notch at the top of the race as
illustrated.
Bobbin case finger
1
Notch
2
2
Hold the bobbin case by the hinged
1
latch.
Note:
If the bobbin case is not properly placed
back into the machine, it will fall out off
the shuttle immediately after starting to
sew.
13