Button Sewing - VERITAS Rachel Instruction Manual

Button sewing

Install the darning plate. (2)
Change presser foot to button sewing foot. Position the work under the foot. (1) Place the but-
ton on the marked position and lower the foot. Set the pattern selector knob on straight stitch
and sew a few securing stitches. Select the zig-zag stitch width according to the distance
between the two holes of the button. Turn the handwheel to check if the needle goes into the
right and the left hole of the button without any obstruction (adjust the stitch width according
to the button). Slowly sew on the button with about 10 stitches. Select straight stitch pattern
and sew a few securing stitches. (3)
If a shank is required, place a darning needle on top of the button and sew. (4) For buttons
with 4 holes, sew through the front two holes first, push work forward and then sew through
the back two holes as described.
32