Dual Feed Foot - VERITAS Rachel Instruction Manual

Dual feed foot

Always try sewing without the dual feed foot first.
It should only be used if necessary.
It is easier to guide the material and you have a
better view of your work when using the standard
foot that is usually fitted on your machine. This
machine enables you to obtain excellent results
when working on a very wide range of fabrics,
from the most delicate muslins to multi-layered
denim.
The optional dual feed foot regulates the feed of
upper and lower layers of material and improves
the correct positioning of checks, stripes and
other design. This foot helps prevent uneven feed
of fabrics that are very difficult to work with.
1. Raise the presser foot bar.
2. Remove the foot holder by tur ning the
clamping screw on the bar anticlockwise. (3)
3. Fit the dual feed foot on the machine in the
following manner;
The forked arm must be fitted in the
needle screw clamping mechanism. (2)
Slide the plastic mounting head from left
to right to install it on the presser foot
bar.
Lower the presser foot bar.
Reinstall the presser foot bar mounting
screw and turn it clockwise to tighten.
4. Make sure the needle clamping screw and
the presser foot bar mounting screw are both
properly tightened.
5. Pull the bobbin thread upwards and place
it behind the dual feed foot along with the
needle thread.
36