Alvarion BreezeACCESS II System Manual page 134

1-2
Accessing the Monitor
Program using the RS 232
MON Connector
1. Use the monitor cable to connect the MON connector of the unit to the COM
port of your ASCII ANSI terminal or PC. The COM port connector on the
monitor cable is a 9-pin D-type plug.
NOTE:
The GU-BS GPS and Alarms module does not have an external MON port. It does have
an internal MON port that can be used in laboratory conditions (consult Alvarion
technical support for further details). It is recommended to use Telnet to access the
monitor program of the GU-BS.
2. Run a terminal emulation program (such as HyperTerminal™).
3. Set the communication parameters to the following:
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Connector
4. Press Enter. The Select Access Level menu appears. Select the access level
according to your authorized access level. You will be requested to enter
your password. After entering the correct password, press Enter.
Table 1-1‚ page 1-2 lists the default passwords for each of the access
levels.
Access Rights
Read Only
Installer
Administrator
NOTE:
Following three unsuccessful login attempts (using incorrect passwords) from either the
monitor port or via Telnet, the monitor program will be blocked for five minutes. To
enable access to the monitor program during that time, the unit must be reset (via
SNMP or by disconnecting/reconnecting power).
Manual Revision: 3.0
BreezeACCESS Version 4.3 Operations and Administration
9600
8
1
None
Xon/Xoff
Connected COM port
Table 1-1: Default Passwords
public
user
private
Password