Advertisement
Attaching to Three-Point Hitch
1. Carefully back the tractor into place.
2. Attach the Zone Commander to the tractor.
3. For tractors equipped with Quick Hitches:
a. Attach Quick Hitch to the Zone Commander.
b. Raise and make sure lower pin locks are
secured.
c. Raise the parking stand and pin in fully up
position.
d. When disconnecting the Zone Commander,
adjust stands to leave the tool bar tilted slightly
forward. This will permit easier disconnecting
and reattaching.
4. For tractors not equipped with Quick Hitch:
a. Attach lower lift arms of the tractor to the Zone
Commander utilizing appropriate pins. 2512
Rigid Model come with either Category IIIN, CAT
III, and CAT IVN. 2512 Folding Models come
with CAT IVN ONLY.
b. Attach top link after connecting lower lift arms.
Raise parking stands into clamps or remove
them on rigid models. For all folding models the
jack stands must be removed from the machine
during transport. When disconnecting, place
stand so that the Zone Commander is stable.
5. Reinstall the stabilizer bars or sway blocks before
transporting.
CAUTION
Do not move tractor without making sure top
hitch is connected to tractor.
F-1049-0421
TABLE OF CONTENTS
(See Figure 4-1)
OPERATION AND MAINTENANCE
Attaching to Caddy
If you will be attaching the Zone Commander to a Caddy:
1. Carefully back the Caddy up to the Zone
Commander.
2. Attach the lower links of the Caddy to the Zone
Commander first.
3. When the lower links have been secured, extend or
retract the upper link of the Caddy using the
hydraulic upper link. Attach the upper link of the
caddy to the Zone Commander.
4-3
Advertisement
