Advertisement
Coverboard Installation
1. Insert four 1/2-13 x 2-1/2 bolts into the coverboard
bracket before attaching the coverboard furrower.
(See Figure
3-5.) Secure with 1/2-13 locknuts and
tighten only so that locking portion of nut engages
the thread. The customer will tighten these nuts after
mounting to shank.
2. Tighten the 7/16-14 flange nut to the 7/16-14 x 1-1/4
plow bolt before tightening the 1/2-13 locknut to the
1/2-13 x 1-1/2 roundhead bolt. This is to ensure that
the point of the coverboard furrower is pulled tightly
against the bracket. Make sure that the plow bolt
head is flush with the surface of the coverboard
furrower.
(See Figure
tightened now.
FLANGED LOCKNUT, 7/16-14
FLANGED LOCKNUT, 1/2-13
LOCKNUT, 1/2-13
COVERBOARD FURROWER
PLOW BOLT, 7/16-14 X 1-1/4
BOLT, 1/2-13 X 1-1/2
Figure 3-7: Coverboard Installation
F-1049-0421
TABLE OF CONTENTS
3-7.) This hardware should be
BOLT,
1/2-13 X 2-1/2
COVERBOARD BRACKET
ASSEMBLY INSTRUCTIONS
Right Hand & Left Hand Coulter
Assemblies
1. Assemble coulter adjustment tube to coulter
assembly using roll pins 1/2 x 4 and 5/16 x 4.
Assemble the coulter stop to the coulter adjustment
tube using 1/2 x 4 screw and nut.
2. Install the coulter adjustment tube and coulter
assembly to the frame using the coulter clamp tube,
4 u-bolts, clamp plate and 5/8-11 locknuts. Do not
tighten nuts until the depth adjustment is completed.
3. Use adjustment pin and 3/16 hairpin to set desired
depth. Tighten 5/8 locknuts on the u-bolts.
4. Attach coulter blade to coulter assembly using 1/2 x
1-1/2 screws and locknuts.
Gauge Wheel
1. The gauge wheel assembly comes fully assembled
from the factory. (Horizontal Mount and Vertical
Mount Options)
2. Attach the tire and wheel assembly to the hub and
tighten the lug nuts to the proper torque as specified
on
Page
2-3.
(See Figure
3-8.)
3-9
Advertisement
