Mounting Bracket And Door Kit Installation Procedure; Important Safety Instructions; Installing Mounting Bracket And Door Kit P/N 60017372 - Vertiv eSure 60017372 Installation Manual

Mounting Bracket and Door Kit Installation Procedure

THESE INSTRUCTIONS SHOULD BE READ THROUGH COMPLETELY BEFORE INSTALLING THE KIT.
The following is a step-by-step procedure to install the kit. The procedure has been written for ease of use and
to minimize the possibility of contact with potentially hazardous energy. This procedure should be performed
in the sequence given, and each step should be completely read and fully understood before performing that
step. Observe all "Important Safety Instructions" starting on page 5 and also those presented in the following
procedure. As each step of the procedure is completed, the box adjacent to the respective step should be
checked. This will minimize the possibility of inadvertently skipping any steps. If the step is not required to be
performed for your site, also check the box to indicate that it was read.

Important Safety Instructions

DANGER! Adhere to the "Important Safety Instructions" starting on page 5 and those listed in the power
system manual.
CAUTION! When performing any step in procedures that requires removal or installation of hardware,
use caution to ensure no hardware is dropped and left inside the unit; otherwise service interruption or
equipment damage may occur.
NOTE!
When performing any step in this procedure which requires removal of existing hardware, retain
all hardware for use in subsequent steps, unless otherwise stated.

Installing Mounting Bracket and Door Kit P/N 60017372

Procedure
[ ] 1. Performing this procedure may activate external alarms. Do one of the following. If possible, disable
these alarms. If these alarms cannot be easily disabled, notify the appropriate personnel to
disregard any future alarms associated with this system while the procedure is being performed.
[ ] 2. Gain access to the distribution panel into which the power extend converter is to be installed.
[ ] 3. Remove the front cover from the P/N 545277 distribution panel. See Figure 1. The front cover and
mounting hardware will not be re-used.
Vertiv | eSure™ Power Extend Converter Mounting Bracket and Door Kit Installation Manual (IM60017372) | Rev. C 9