Table of Contents
Advertisement
[ ] 3. Ensure the enable/disable switch on the power extend converter is in the disable (down)
position. See Figure 12. Repeat for each power extend converter to be installed.
Figure 12:
Enable/Disable Switch
[ ] 4. Connect the return wire (P/N 564330) to a power extend converter. See Figure 11. Orient the white
square on the return wire faston receptacle's locking tab as shown in Figure 11. Plug the power
extend converter into the distribution panel. See Figure 13. Repeat for each power extend
converter to be installed.
[ ] 5. Secure the power extend converter(s) to the mounting bracket with the screw provided with the
power extend converter. Torque as shown in Figure 13. Repeat for each power extend converter to
be installed.
NOTE!
The front mounting bracket can be adjusted up and down as needed for power extend
converter installation.
[ ] 6. Once all power extend converters are installed, tighten the front mounting bracket to the left and
right side mounting brackets. See Figure 3 and Figure 4. Torque hardware to 9.6 in-lbs.
Vertiv
| eSure™ Power Extend Converter Mounting Bracket and Door Kit Installation Manual (IM60017372) | Rev. C
Ensure the enable/disable switch
on the power extend converter is
in the disable (down) position
before installing.
Status Indicator
Enable
Enable / Disable Switch
Disable
Vout+
Output Voltage Test Points
Vout-
21
Advertisement
Table of Contents
