Installing The Power Extend Converter(S) - Vertiv eSure 60017372 Installation Manual

Installing the Power Extend Converter(s)

NOTE!
See also "Restrictions" on page 16.
Procedure
[ ] 1. Move the grounding tab from the top of the power extend converter to the bottom per Figure 10.
Repeat for each power extend converter to be installed.
Figure 10:
Moving Grounding Tab from Top of Unit to Bottom
Move grounding tab from top of unit to bottom by removing the screw
securing it to the top. Set the grounding tab and screw aside. Remove
the bottom screw. Secure the screw removed from the bottom location
into the top location (note that it is a different length then the screw used
to secure the grounding tab). Orient the grounding tab in the bottom
location as shown in the illustration and secure with the screw removed
from the top location (longer screw). Torque both screws to 5.8 in-lbs.
[ ] 2. Connect the return wire (P/N 564330) provided with the power extend converter to a power extend
converter return wire faston tab (P/N 565990) installed on the cabinet's return bar in a previous
step. See Figure 11. Repeat for each power extend converter to be installed.
NOTE!
The furnished 4-inch long return wire jumper (P/N 565752) may be installed with the P/N
564330 return wire if additional return wire length is preferred.
NOTE!
The power extend converter is also furnished with an 8-inch long return wire jumper P/N
566207. The 8-inch long return wire jumper is not used with this mounting bracket kit. It is used in
other kits.
Vertiv | eSure™ Power Extend Converter Mounting Bracket and Door Kit Installation Manual (IM60017372) | Rev. C
M3 x 6 mm
M3 x 4 mm
Flat Head Screw
Flat Head Screw
M3 x 4 mm
Flat Head Screw
M3 x 6 mm
Flat Head Screw
19