Appendix D: Vertiv™ Kvm Switch Bracket Kit (Drmk-81) - Vertiv KMMLED156 Installer/User Manual

Appendix D: Vertiv™ KVM Switch Bracket Kit (DRMK-81)
The 1U rack mount KMMLED156 assembly enables you to mount a KVM switch behind the KMMLED156 assemblyin the
same 1U space.
NOTE: The minimum EIA flange spacing for the console tray and console switch is 450 mm.
Figure D.1 KVM Switch Installation
Table D.1 KVM Switch Installation
ITEM DESCRIPTION
1 Securing the kit brackets to the KVM switch
2 Aligning the brackets with the brackets in the rack
3 Sliding the KVM switch towards the console tray
To attach the mounting brackets and install your KVM switch:
1. Remove any brackets and standoffs that shipped with the KVM switch.
2. Using the four screws provided in the DRMK-81 kit, attach a bracket from the kit to each side of the KVM
switch.
3. Route the provided cables through the cable channel on the side of the switch.
4. From the back of the rack, push the KVM switch in behind the KMMLED156 assembly and secure the switch
with the supplied thumbscrews.
5. Connect the switch to the console tray and connect any servers or target devices to the switch. See
the KMMLED156 Assembly
Vertiv | KMMLED156 Rack Mount 15.6" Console Tray for Dell EMC Installer/User Guide |
on page 10.
Connecting
24