Table of Contents
Advertisement
Figure 13:
Installing Power Extend Converter(s)
Power Extend Converter
Return Wire Not Completely
Shown for Clarity Only
Plug the C4858
Series Power Extend
Converter into the
distribution position.
[ ] 7. Place the enable/disable switch on the power extend converter to the enable position. See Figure
12 on page 21. If two or three power extend converters are connected in parallel to a load that
exceeds 1000 watts peak, they should be switched on simultaneously.
[ ] 8. Observe the status of the power extend converter front panel local indicator. If operating normally,
this indicator should be illuminated green. See Figure 12 on page 21.
[ ] 9. Close and secure the door.
[ ] 10. Ensure that there are no local or remote alarms active on the power system.
[ ] 11. Enable the external alarms or notify appropriate personnel that this procedure is finished.
Vertiv
| eSure™ Power Extend Converter Mounting Bracket and Door Kit Installation Manual (IM60017372) | Rev. C
Secure at the bottom
with the screw supplied
with the power extend
converter. Torque to
9.6 in-lbs.
22
Advertisement
Table of Contents
