Mitsubishi Electric Melsensor VS70 User Manual page 61

4.
Place a spacer on the vision sensor.
When placing the spacer, check the position of the character, "TOP" on the spacer to place it in the same
direction as the figure below.
5.
Check that the gasket is located under the spacer.
6.
Insert four M3 × 6 mm screws, and tighten them using a 2 mm hex wrench in the order of one to four shown in the
following figure.
1 4
3 2
The maximum tightening torque is 0.34 N⋅m.
7.
Thread a lens into the vision sensor.
TOP
6 SYSTEM CONSTRUCTION
6.3 Attachment of a Lens and Light
6
59