Mitsubishi Electric Melsensor VS70 User Manual page 55

When placing the autofocus module, check the position of two alignment pins on the bottom of the autofocus
module to place it in the same direction as the following figure.
8.
Temporarily fasten the three captive screws on the top of the autofocus module using a 1.5 mm hex wrench.
9.
Tighten the captive screws with a force of 0.50 N⋅m using a torque screwdriver with a 1.5 mm hex torque bit capable of
reaching 15 mm into a 2.5 mm diameter hole.
10.
Check that the gasket is located on the spacer, and place the light housing.
When placing the light housing, check the position of the character, "TOP" on the light housing to place it in
the same direction as the following figure.
11.
Insert captive screws into the four captive screw access holes near the white circles on the LED ring light, and tighten
them using a 2 mm hex wrench in the order of one to four shown in the following figure.
1 4
3
The maximum tightening torque is 0.34 N⋅m.
TOP
2
6 SYSTEM CONSTRUCTION
6.3 Attachment of a Lens and Light
6
53