Table of Contents
Advertisement
Tool
Defect Detection Tools
Calibration Tools
*1 For VS70M-600-ER, VS70M-600-R, VS70M-800-ER, VS70M-800-R, VS70M-802-ER, and VS70M-802-R, the following patterns can be
used: PatMax RedLine Pattern and PatMax RedLine Patterns (1-10).
As for VS70M-600-E, VS70M-600, VS70M-800-E, VS70M-800, VS70M-802-E, and VS70M-802, the following patterns cannot be used:
PatMax RedLine Pattern and PatMax RedLine Patterns (1-10).
4.3
Interface List
The following table shows the interfaces that can be used in In-Sight Explorer.
Interface
EasyBuilder
Spreadsheet
4 FUNCTIONS
32
4.3 Interface List
Settings
Surface Flaw
Edge
Edge Pairs
Edge Width
Bead Finder
Bead Tracker
N Point
Sequential N Point
Description
To edit a job with an EasyBuilder interface.
To edit a job with an Spreadsheet interface.
Description
To detect whether or not small flaws based upon pixel intensity variations.
To create a best fit line or circle, and determines whether or not there are deviations, such
as defects or gaps.
To create a pair of best-fit line or circle, and determines whether or not there are deviations,
such as defects or gaps.
To measure and verify that the thickness of a pair of edge is within tolerance.
To detect a bead feature (defined by a pair of edges), regardless of shape, by detecting the
center of the bead and creating a region that can be used to inspect the width of the bead.
To inspect the location, shape, and width of a beard feature, and determine if the bead is in
the correct position, based on a use-defined edge model of a bead feature (defined by a
pair of edges).
To create a calibration that can be exported to share among jobs, using 2 to 16 point pairs.
To create a calibration that can be exported to share among jobs, using 2 to 16 point pairs
and images that are sequentially captured.
Advertisement
Table of Contents
