Mitsubishi Electric Melsensor VS70 User Manual page 56

12.
When using a bandpass filter, insert the filter in the light baffle so that it's held in place between the light baffle's filter
tabs.
13.
Push the filter down and snap it into the prescribed place.
14.
Check that the filter retention tabs are flush with the top surface of the filter.
15.
Tilt the light baffle toward the light housing, and maneuver the light baffle under the LED ring light in order from the
bottom.
Light baffles are designed to fit the structure of LED ring lights.
When placing the light baffle, check the position of the character, "TOP" on the light baffle to place it in the
same direction as the following figure.
6 SYSTEM CONSTRUCTION
54
6.3 Attachment of a Lens and Light
TOP