Front panel
Operate indicates the operational status of the SDA-2400:
•
Strong light – The SDA-2400 is operationg normally.
•
Flashing – The SDA-2400 is in standby mode.
Rear panel
1. Trigger in and out
In order to control the power state from another product (ex: pre-amplifiers
or media players) with trigger control, the SDA-2400 is equipped with 3.5
mm mono mini jack sockets.
•
If there is a plug in the "Trigger In" socket with no voltage applied,
the SDA-2400 is in standby mode.
•
If a DC voltage of 5-24V or a 50Hz AC voltage of 4-17Vrms is
applied, the SDA-2400 will go into Operate mode.
•
"Trigger Out" is for daisy-chaining other SDA-2400s and controlling
them all by the same signal. Connect the control signal to "Trigger
In" on the first SDA-2400 and connect its "Trigger Out" to "Trigger
In" on each subsequent unit.
•
When a trigger cable is used, the Power State must be set to "On".
2. Power state
As the SDA-2400 has an extremely low power consumption in standby
mode, there is no on/off switch on the front of the product. Instead, power is
controlled automatically by the amplifier.
Lyngdorf Audio SDA-2400 – Owner's manual
ENG
DE
FR
10