Lyngdorf Audio SDA-2400 Owner's Manual page 11

•
Set the Power State switch to "On" if you want the SDA-2400 to
turn on/off by trigger control, or if you want to keep the SDA-2400
permanently on.
•
Set the Power State switch to "Low Power" if you want the SDA-
2400 to turn on/off by a sound signal from the selected input. If no
signal is detected for around 30 minutes, the amplifier will go into
standby mode.
3-4. Analog unbalanced and balanced input
For connection to products with analog output, you may only connect to
one input at a time. The input sockets are internally connected in parallel,
so ALWAYS use EITHER the XLR inputs OR the phono inputs. Do not use
both at the same time, as this will induce noise.
5-6. Coaxial input and optical input
For connection to products with digital output, Coaxial (SPDIF) and Optical
(Toslink) inputs are available.
7. Input select
Set the selector to the input in use.
8. Loudspeaker connectors
Connect your speakers to Left and Right connectors. The connectors allow
for use of banana plugs and bare wire up to 5mm2.
9. Voltage selector
The voltage selector must be in the position for your local mains supply.
10. Mains connector and switch
Be sure that the power cord is inserted firmly in the connector. The mains
switch will remove the amplifier from your mains power.
Lyngdorf Audio SDA-2400 – Owner's manual
ENG
DE FR
11