RoboLabs ROBOPOP 60 Operating Manual page 13

Program change
To switch the program, press PAUSE button. Corn supply will stop immediately.
It will take 3 minutes to finish processing of corn kernels in the chamber. After
this, two program buttons, Butterfly and Mushroom, will appear on the screen.
Cooling down
To stop the operation, TURN OFF button should be pressed. Corn feeding will
be stopped immediately. Corn in the chamber will be processed. If Butterfly
program was chosen, oil and salt application will be active for some time.
Cooling takes some time, after a while the main screen appears.
Turning off
To turn the machine off, press and hold TURN OFF button. Also, machine will
be turned off automatically after 10 minutes if nothing pressed.
Chamber clogging
If you see "Chamber is clogged with popcorn" message then do the following.
DO NOT OPEN CHAMBER DOOR UNTIL MACHINE IS COOLED DOWN. DO NOT USE FIRE
EXTINGUISHERS!
1. DO NOT panic and DO NOT use fire extinguishers!
2. Patiently wait for machine cooling down.
3. Once turbine is stopped, turn the machine off. To do this, press and hold
TURN OFF button.
4. Machine is still hot. Wait few hours to let machine cool down completely.
5. Take out the door and clean up the chamber. Pay attention to chamber inner
hollows as well as to corn delivery tube, which may be clogged with popped and
unpopped popcorn. Use a suitable tool (piece of cable, or probe or hose), which
is flexible and strong enough for shattering the clog inside the tube.
6. Once chamber is clean close the door and turn the machine on. Release
OVER.LOCK indicator. See section 2.4.
CHAMBER CLOGGING CAUSED BY ACTIONS OF UNEXPERIENCED USERS OR IMPROPERLY
CHOSEN PARAMETERS IS NOT A WARRANTY CASE!
tm2692 Jan-20
13