5.23.3.2 SENSOR
Lets the user select a custom sensor or one of our preset
flow sensor types.
5.23.3.3 SHUTDOWN
Allows the user to select if the controller should shut down
operation per zone or by system.
5.23.3.4 LINEFILL
The time it takes for the system to completely fill the line.
5.23.3.5 SAMPLE T
How often the controller reads flow pulses from the Aircard.
5.23.3.6 LEAK DET
A settable value that determines when the controller will
produce a Leak Detect fault.
5.23.3.7 LOW LMT
The lowest flow value the controller can sense without
producing a fault.
5.23.3.8 HIGH LMT
The highest flow value the controller can sense without
producing a fault.
5.23.4 TOT FLOW
Shows the daily total flow for each zone. Can scroll through each
zone for a 7-day history.
5.23.5 LOW PK
Shows the lowest flow value for each individual zone, can scroll
through each zone for a 7-day history.
5.0 Advanced Menu
5.24 SLW
5.24.1 RAIN
The rain selection is on/off toggle to override the SLW sensor
feature for selected zones. Factory default is ON for all zones.
5.24.2 FREEZE
The freeze selection is on/off toggle to override the SLW freeze
sensor feature for selected zones. Factory default is ON for all
zones.
5.24.3 DELAY
This feature allows the user to adjust the factory set 48 hour
watering delay that will occur after a rain event shutdown if
you are using an SLW Weather Sensor. To eliminate the delay
or to reduce or increase the factory default hours, turn the dial
to Advanced Menu and use an UP and DOWN button to select
SLW DLY. Press the NEXT button and 48 hours will show in the
display. Use the UP and DOWN buttons to eliminate the delay
or to select a different number of hours (0–99 hours). Note: The
SLW DLY begins after the SLW rain sensor has reset following
a rain event. Accumulation of new water deficits will not begin
until after the SLW DLY has cleared.
19
http://support.weathermatic.com