Weathermatic SmartLine SL800 Owner's Manual page 33

6.0 Troubleshooting the Controller
26
PROBLEM
SmartLine® controller does
not turn on zone when
expected
http://support.weathermatic.com
CAUSES
Sensor jumper is removed and no
sensor is connected (Sensor LED
is red)
Sensor wires have been cut
(Sensor LED is red)
Zone comes on at unexpected
time
Stacked program has
commenced normal operation
Time of day or date not set
properly
Watering days or omit days/dates
not set properly
Run/Soak feature has extended
watering window
Controller does not operate zone
for expected run time
Module not installed
No initial AC power-up of
controller
SOLUTIONS
Install jumper wire between SEN terminals
Select OFF mode if desired
Repair wires
Program daily start times not set properly or multiple start times set.
Check Program Start Times
Modify settings (such as program start times, zone run times) to
prevent stacking if undesirable
Review/set time of day and date
Review/set watering days or omit days/dates
Normal operation to allow water infiltration and prevent runoff
Pause for Run/Soak in progress. This is normal operation to allow
water infiltration and prevent runoff
Check seasonal % settings if BASIC mode is in use.
Install module
Connect AC power and close control panel