5.0 Advanced Menu
16
5.8.7
EEPROM
Displays the amount of EEPROM available in bytes.
5.8.8
SLHUB VER
Displays the version of the RFS weather sensor. NI is show if this
is not installed.
5.8.9
SLHUB BLD
Displays the build version of the RFS weather sensor. NI is show
if this is not installed.
5.8.10 SLAC B VER
Displays the version of the aircard. NI is show if this is not
installed.
5.8.11 SLAC B BLD
Displays the build version of the aircard. NI is show if this is not
installed.
5.8.12 Z96 TYPE
Displays the decoder manager type if SmartWire equipped.
5.8.13 Z96 VERS
The display reads Z96 VERS here.
5.9 MODBUS
5.9.1 SHORT ADD
This displays a static address along with a user programmable
address to integrate with third party software.
5.10
CLR ALL
This feature is similar to CLR PGM except that it clears all user
programmed data for all four programs and returns most
Advanced Menu changes to factory defaults. Turn the dial to
http://support.weathermatic.com
Advanced Menu and use and use the UP button to navigate to
CLR ALL. Press the NEXT button and the screen will display
CONFIRM. Press the NEXT button once more and the display will
show CLEARING when finished to confirm that all programs have
been cleared.
5.11 CLR PGM
This feature allows the user to clear all programmed values
specific to a selected program. All zone run times and daily
start times will be set to OFF; watering days will default to Days
of the Week (all on); Season % will equal 100% for all months
and Run/Soak will be OFF. Omit times/days are not reset when
clearing a program.
Turn the dial to Advanced Menu and use the UP button to
navigate to CLR PGM. Press the NEXT button and the display will
read CONFIRM. Use the PGM button to select the program (A,
B, C or D) to be cleared. Press the NEXT button and when the
selected program has been cleared from the panel the display
will read COMPLETE. Repeat these steps to clear each individual
program to be reset.
5.12
CON PGM
Select the ability to run 1, 2, 3, or all 4 programs simultaneously.
Default is two simultaneous programs. Programs will prioritize
with the order of priority being: A, B, C, D.
5.13
NC/NO MV
Enter this menu to select between normally open or normally
closed master valves for MV1 and MV2.