Mode Button - Weathermatic SmartLine SL800 Owner's Manual

On the SmartLine® controller, verify that the antenna icon
appears on the bottom line of the LED display. (Note: The icon
will flash for 1 minute at the time of a communication. The icon
will be static between communication events.) The antenna
indicates communication has been established. The SLW
Weather Sensor provides rain and freeze pause functions to
prevent watering during periods of rain and freezing weather.
The rain override will pause watering after a minimum of 1/8th
inch of rainfall is received (the factory setting of 1/8th inch can
be changed incrementally up to 3/4 inch by sliding the rain
sensor into the desired position). The SLW Weather Sensor will
also pause watering when the outside temperature drops to
37 degrees Fahrenheit (1.5 degrees Celsius). The Sensor LED
will display RED during these rain or freeze periods. Controller
operation will resume when the temperature is again above 37
degrees F (1.5 degrees Celsius). However, after a rain event, the
SmartLine® controller will block watering for the amount of time
set in SLW DLY.

4.2.6 MODE Button

WATERING
Press the MODE
button on the control
panel to place the SmartLine® controller in the SMART mode. A
GREEN LED on the SMART position will confirm that you have
communicated with the SLW Weather Sensor. If there is no SLW
Weather Sensor installed or ZIP Code or Latitude or time/date
setting and at least one zone with a sprinkler type set, pressing
the MODE button will flash the SMART LED to RED and then
return to the BASIC mode. When this occurs, you can press the
MODE button to see a scrolling message indicating the reason
SMART mode is not available.
SMART
MODE
BASIC
4.0 Programming for Smart Watering Mode
11
http://support.weathermatic.com