Powering Off The Projector - Barco G100 Installation Manual

5.2 Powering off the projector

How to power the projector off
1. Press the POWER button (2) on the control panel or the OFF key (5) on the remote control.
A message will prompted on screen to confirm if you want to turn off the projector.
2. Press the POWER button or OFF key again to confirm. If not, the message will disappear after 10 seconds
and the projector will remain on.
The projector will go to standby mode.
3. Once the projector has entered standby mode and you want to turn the projector off completely, power off
the AC switch.
Tip: If you still plan to use the projector in the foreseeable future, it is recommended to keep the
projector in standby mode. Only turn off the projector completely if you want to physically move
the projector, or if you do not plan on using the projector for the foreseeable future.
CAUTION: It is not recommended to turn the projector on immediately after powering off the
projector.
Powering on/off the projector
R5913458 /01 G100 59