Table of Contents
Advertisement
Installation procedures
The update starts. This action can take a long time. A message is displayed.
9.
Click Yes to continue (4).
The update file will be transferred to the projector and installed. The projector will reboot.
A message is displayed. Click Ok to clear the message.
How to update the software if the projector isn't connected to the network
1.
Power on the projector.
2.
Download the latest firmware file ( format .iso) from Barco's website. The firmware can be downloaded for
free from Barco's website, (URL: http://www.barco.com). Click on myBarco and log in to get access to
secured information. Registration is necessary.
If you are not yet registered, click on New to myBarco and follow the instructions. With the created login
and password, it is possible to log in where you can download the software.
3.
Connect your computer to the projector, using a LAN cable.
4.
Browse to the IP address of the projector (e.g. the default 192.168.1.100).
The login screen will be displayed.
Image 3–7 Example of the login page
5.
Log in, using the following (default) settings:
•
Username: admin@g100
•
password: admin@g100
Tip: It is advised to change the username and password once you have logged in. It is also
advised to use a strong password.
6.
Navigate to System Settings > Upgrade (reference 1).
The upgrade page will be displayed.
46
R5913458 /01
G100
Advertisement
Table of Contents
