Table of Contents
Advertisement
3.4 Projector Address (ID)
About the projector address
The Remote Control supports individual addressing of multiple projectors. The remote receiver on the
projector can be set with a specific number from 00 to 99, and the projector only responds to the IR remote set
to the same number. The default ID code of the RCU (also known as the broadcast address) is 00. This
specific address allows the RCU to control all projectors within its effective range.
How to set the projector address on the RCU
1.
Press for at least 3 seconds on ID Key (reference 5).
2.
Enter the address with the numeric keys (reference 3). Always enter 2 digits.
Tip: Always enter two digits. E.g. for address 2, enter 02.
The projector address can be set in: Communication > Remote setup > Remote code.
Installation procedures
R5913458 /01
G100
43
Advertisement
Table of Contents
