Add Cid Events For Transcoding; Edit Encoding Device Event And Device Online/Offline Event - HIKVISION Hik IP Receiver Pro User Manual

Note
At most 5,000 events can be printed.

6.3 Add CID Events for Transcoding

The ARC receives events from AX Pro by event codes. The Hik IP Receiver Pro will receive an event
code (which is defined as an original code) when an AX Pro added to the Hik IP Receiver Pro
detects an event. Then, the Hik IP Receiver Pro transfers the original code to a target code which
could be received by the ARC. After that, the Hik IP Receiver Pro sends the target code to the ARC.
In this way, you can receive event notifications by the ARC.
Click Automation Output → Event → CID to enter the CID Event Configuration page. Perform the
following operations and save the settings.
• Click Add to enter the event name, original code, and target code.
• Click on Operation column to delete an event. You can check multiple events, and click Delete
to delete these events in a batch.
• Click on Operation column, and edit Event Name and Target Code.
Note
If you delete an event type, the Hik IP Receiver Pro will send the original code to the ARC without
trans-coding to target code, and the ARC cannot recognize the event.

6.4 Edit Encoding Device Event and Device Online/Offline Event

You can edit the information of encoding device event and device online/offline event to keep it
the same with the information configured on the ARC if necessary.
Hik IP Receiver Pro User Manual
Figure 6-2 CID Event Page
21