HIKVISION Hik IP Receiver Pro User Manual page 12

3. Optional: Click Add Zone to add a zone for the device.
Note
• For encoding devices and third-party devices, you need to add zones for them on the Hik IP
Receiver Pro, and zone No. should be the same with the zone No. configured on ARC.
• For AX Pro, the Hik IP Receiver Pro will automatically get zone information and linked
channels configured on the device. So you do not need to add zones for AX Pros on the Hik IP
Receiver Pro.
• Make sure the zone information you set are the same with the zone information set on ARC,
or the Hik IP Receiver Pro will fail to transmit videos from the zones-linked channels to ARC.
4. Link channels to zone.
1) Select a zone and click Selected Channels to enter the Link Channel page.
2) Select an encoding device on the left.
Channels of the device are displayed on the right.
Note
• You can only select encoding devices in the same site with the AX Pro on Hik-ProConnect.
• For encoding devices, you can only link their own channels to their zones.
• For third-party devices, you can link channels of devices in any other sites to their zones,
but the third-party devices and the linked channels should share the same ARC.
3) Check channels to be linked and click Save.
Note
No more than four channels can be linked to a zone.
The linked channels are displayed on the alarm service and zone settings page.
Hik IP Receiver Pro User Manual
Figure 3-1 Enable Alarm Service and Set Zone
8