Set Nic For Hik Ip Receiver Pro; Set Nat - HIKVISION Hik IP Receiver Pro User Manual

Device Port
Click Device Port to edit the ports used for data transmission from the Hik IP Receiver Pro to
devices.
Note
Restart the Hik IP Receiver Pro after editing the device port, or the settings will not take effect.

4.4.2 Set NIC for Hik IP Receiver Pro

For the Hik IP Receiver Pro running on the PC with multiple NICs, you need to select one NIC for
communication.
Steps
1. Click Configuration → Network → Access Network to enter the NIC setting page.
2. Click in the IP Address column to switch the NIC.
3. Click Save to save the settings.
Note
• By default, the Hik IP Receiver Pro will restart automatically after saving the settings.
• You should restart the Hik IP Receiver Pro after editing the IP address of the computer where
the Hik IP Receiver Pro runs.
• If you have edited NIC for the Hik IP Receiver Pro, make sure the server address configured on
the device is the same with the selected NIC.

4.4.3 Set NAT

If port mapping is required, you need to set the parameters of port mapping on a router
beforehand, and then enter the external port number and external IP address on the NAT page.
Click Configuration → Network → NAT to enter the NAT setting page. Check Enable to enable
Platform Port Mapping or Device Port Mapping function. Enter the corresponding external ports
and external IP addresses of the Hik IP Receiver Pro and save the settings.
Platform Port Mapping
Used for accessing the Hik IP Receiver Pro by Web browser.
Device Port Mapping
Used for receiving data from ISUP devices. Once it's disabled, the function of linking directly or by
Hik-ProConnect Server cannot be used.
Hik IP Receiver Pro User Manual
12