Physical Installation - Emerson Rosemount 702 Quick Start Manual

Wireless discrete transmitter

Hide thumbs Also See for Rosemount 702:

April 2021

Physical installation

The Rosemount Transmitter can be installed in one of two configurations:

•

Direct mount, where the switch is connected directly to the Rosemount

702 Transmitter housing's conduit entry.

•

Remote mount, where the switch is mounted separate from the

Rosemount 702 Transmitter housing, then connected to the Rosemount

702 Transmitter.

Select the installation sequence that corresponds to the mounting

configuration.

3.1

Direct mount installation

Note

Direct mount installation should not be employed when using tubing and

connectors such as Swagelok

Figure 3-1: Direct Mount

A. Rosemount 702 Transmitter

B. Float switch

Procedure

1. Install the switch according to standard installation practices making

sure to use thread sealant on all connections.

2. Attach the Rosemount 702 Transmitter housing to the switch using

the threaded conduit entry.

3. Attach the switch wiring to the terminals as indicated on the wiring

diagram (see

circuits, and leak

Quick Start Guide

fittings.

Reference information: wiring switch inputs, output

sensors).

Quick Start Guide

Table of Contents