Setting The Timer - Aiwa CA-DW630 Operating Instructions Manual

5 Press the POWER button to turn the unit off
SETTING THE TIMER
The unit can be turned on at a specified time every day with
the built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press the TIMER button on the remote control
to display ~, and press the SET button within 4
seconds.
0
and the hour flash.
NOTE
If you do not press the SET button within 4 seconds,
another operation may start.
Designate the hour of the timer-on time by
pressing the ++ or _ button, and the SET
button. Repeat to designate the minute of the
timer-on time.
Within 4 seconds, select the duration for the
timer-activated period with the ++ or -
button, and press the SET button.
The duration for the timer-activated period can be set
between 5 and 240 minutes in 5-minute steps.
If this step is not completed within 4 seconds, repeat
from step 1.
Prepare the
source.
To listen to a
CD,
press the CD button and load the
disc.
To
listen to
the
radio,
press the TUNER/BAND button
and tune in to a station.
after adjusting the volume.
@
remains on the display after the power is turned off
(timer standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 21 when the
power is turned off with the volume level set to 22 or
more.
To check the specified time
Press the TIMER button on the remote control. The timer-on
time flashes for
4
seconds. However, the duration for the
timer-activated period will not be displayed.
To cancel timer standby mode temporarily
Press the TIMER button on the remote control twice to turn
off a.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 4 to prepare the
source, and adjust the volume.
NOTE
Timer playback will not begin unless the power is turned
off .
Connected equipment cannot be turned on and off by the
built-in timer of this unit. Use an external timer.
14
ENGLISH