Setting The Clock - Aiwa CA-DW570 Operating Instructions Manual

SETTING THE CLOCK
1,3,5
2,4
2,4
1,3,5
1
2
3
4
5
When the AC cord is connected for the first time, AM I 2:00 flashes.
Set
the time as follows while the power is off.
1
2
3
4
5
Keep the II SET button pressed for about half a
second.
The hour flashes.
Press the + DOWN or > UP button to
designate the hour.
Press the II SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the ~ DOWN or > UP button to
designate the minute.
Press the II SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn off the unit and carry out steps 1
to 5 above.
To switch to the 24-hour standard
Press the STOP button in clock setting mode. Repeat the
same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to be reset.